20
[email protected]
www.boschert.de
Mattenstraße 1
79541 Lörrach-Hauingen
Tel.: +49 (0) 7621 - 95 93 0
Fax: +49 (0) 7621 - 55 18 4
Changes reserved
Version: 01/ 2004
Description
4.1
Operating keys and pertaining LED’s
1) Key Hydraulics on (ON, OFF)
2) Key Pneumatics on (ON, OFF)
4.2
Modes of operation
Not active on fixed angle machines.
The hydraulic system can be activated by pressing this key (it is located on the top right-hand
side of the operator panel). The hydraulic system may be turned off again by operating the
same key.
The condition HYDRAULICS ON is indicated by the LED above the PROG key.
The hydraulic system is controlled by a high performance integrated circuit. If the hydraulic
system is switched off during the operation, all outputs from this circuit to the hydraulic system
are also stopped.
The pneumatic system can be activated by pressing this key (it is located on the bottom right-
hand side of the operator panel). The pneumatic system may be turned off again by
operating the same key. The condition ‘‘Pneumatics on“ is indicated by the LED above the
key.
A high performance integrated circuit output ‘‘left“ or “right“ can only be accessed if the
pneumatic system is switched on. If the pneumatic system is switched off via this key during a
running movement, the tow high performance integrated circuit outputs accessed via the
pnuematic system are also switched off by the software.
AIR functions only in machines with a pneumatic device.
3 modes of operation can be set by LEDs:
*CONTINUOUS STROKE
left LED
*SINGLE STROKE
center LED
*SET-UP
right LED
