en
operation
32
3.
Fold the measuring aid down and
click it into place.
4.
Push in the detergent drawer.
13.7 Adding detergent and
care product
Notes
¡
Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡
Observe the information about de-
tergents and care products
→
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.8 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 30
▶
Press
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "End".
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
.
3.
To resume the programme, after
the desired soaking time, press
.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
1.
Press
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
.
13.11 Cancelling the pro-
gramme
1.
Press
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
