Bosch WFL 2060UC, Training Program

Page: 54 / 84

WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Test Program (3)
Test Program (3)
54
To enter comprehensive test program for WFL 2060 washers
(
to test entire washer or check last
wash fault):
♦
Rotate
cycle selector
knob to
Off
position and rotate
spin speed
knob to 1000 RPM.
♦
Push and hold
Start
button (or
Rinse Plus
and
Quick Wash
buttons at the same time), then rotate
cycle selector
knob
cw
to
Power Temp Boost
position. After rotating
cycle selector
knob, keep holding
Start
button (or
Rinse Plus
and
Quick Wash
buttons) at least 3 seconds until
Door locked
&
Rinse/Spin
lights come on. Washer is now in the
comprehensive test program.
♦
Lights will
flash
for wash faults -- fault shown will be the last fault code on the washer (see fault chart on following page).
♦
When test program has been entered:
♦
Door locked & Rinse/Spin
lights will come on (and stay on).
♦
See chart on 5th test program page for test sequence.
♦
Test ends automatically (after ~ 2 minutes, 20 seconds when
Door locked
&
Rinse/Spin
lights come on) and
automatically restarts. To end test (at any time), rotate
cycle selector
knob out of
Power Temp Boost
position (to any
position). If a fault has occurred during test, check fault chart to determine failed part.
Door locked
Rinse/Spin
Wash
NOTE:
Fault displayed will be
1
st
fault that occurred since last time
washer was turned on.
NOTE:
Do not push
Start
button (or
Rinse Plus
&
Quick Wash
buttons) within 5 seconds of rotating
cycle selector
knob to
Power
Temp Boost
position while selecting comprehensive test program or while test is restarting. If so, individual part (component) test
program will begin -- use
Start
button to manually advance through each step.
1st Edition/Revision 5 (1/20/04)