Bosch WFL 2060UC, Training Program

Page: 52 / 84

WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Test Program (1)
Test Program (1)
52
The WFL 2060UC washers have test programs enabling the washers to
self-diagnose problems, including listing the last fault code.
To enter component test program for WFL 2060 washers
(
to test individual parts or check last
wash fault):
♦
Rotate
cycle selector
knob to
Off
position.
♦
Push and hold
Start
button (or
Rinse Plus
and
Quick Wash
buttons at the same time), then rotate
cycle selector
knob
ccw
to
Permanent Press Cold
position. After rotating
cycle selector
knob, keep holding
Start
button (or
Rinse Plus
and
Quick Wash
buttons) at least 3 seconds until
Door locked
&
Rinse/Spin
lights come on. Washer is now in the
component test program.
♦
Lights will
flash
for wash faults below. Fault shown will be the last fault code on the washer (see fault chart below).
♦
When test program has been entered:
♦
Door locked & Rinse/Spin
lights will come on (and stay on).
♦
Select individual parts to test by rotating
cycle selector
knob as shown on next page. Don’t rotate
cycle selector
knob through
Off
position while selecting tests (so washer won’t shut off).
♦
Once part to test has been selected, start test by pushing
Start
button. Push
Start
button again to end any test
(except for rotating
cycle selector
or
spin speed
knob to end
motor
test).
♦
To exit test program, push
Start
button.
Door locked
Rinse/Spin
Wash
NOTE:
Fault displayed will be
1
st
fault
that occurred since last time washer
was turned on.
NOTE:
Door locks for all water fill and
drain tests. Door unlocks ~ 30
seconds after drain pump test ends
(after all water has been drained).
1st Edition/Revision 5 (1/20/04)