Notice!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT.
Refer to your keyboard manual for the key naming conventions.
–
Command numbers range from 1 to 999. See Keyboard Commands by Number, page 45
for a complete list of keyboard commands.
–
The Enter key can also be labeled with the ∞
�
symbol.
For example, the keyboard command to make the AutoDome pan 360º continuously is:
ON-1-ENTER (press the ON key, then press the number 1 key, and then press ENTER.)
Setting the Camera Address
Once the AutoDome power is turned on and homing is complete, you must set the camera
address. You may also want to assign a password and customize some of the AutoDome
default settings.
Notice!
You do not need to set a camera address if using Bilinx or Ethernet communication. See the
VG5 AutoDome Installation Manual to configure an AutoDome for Bilinx or Ethernet operation.
FastAddress
FastAddress is an AutoDome feature that allows you to set or change a camera address using
the keyboard and on-screen menus.
There are three (3) FastAddress commands:
–
ON-999-ENTER: Displays and programs all cameras without an address in the system.
Notice!
If a keyboard is set to a camera number that already has an address, that camera also
responds to this command.
–
ON-998-ENTER: Displays and programs all cameras with or without an address in the
system.
–
ON-997-ENTER: Displays the current address status of all cameras in the system
simultaneously.
To set an address for a camera without an address:
1.
Select the camera number you want to FastAddress. The system displays the camera
number on the keyboard and the image on the corresponding monitor.
2.
Press #-ENTER (where # is the camera number without an address).
3.
Press ON-999-ENTER to invoke an on-screen display of cameras on the system without an
address.
4.
Follow the on-screen instructions. You receive an on-screen confirmation when the
FastAddress is complete.
To change or clear an address for a camera with an address:
1.
Select the camera number you want to FastAddress. The system displays the camera
number on the keyboard and the image on the corresponding monitor.
2.
Press #-ENTER (where # is the camera number with an address).
3.
Press ON-998-ENTER to invoke an on-screen display of all cameras on the system, with or
without an address.
1.3
1.3.1
AutoDome 600 Series Analog PTZ
Camera
Getting Started | en
7
Bosch Security Systems, Inc.
User Manual
2014.11 | 2.1 | F.01U.270.005
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en User Manual ...
Page 2: ......
Page 67: ......
