Boiler block assembly
|
17
6 720 648 162 (2011/08)
5
Boiler block assembly
The on-site installlation is carried out using individual
sections if, because of physical limitations, a boiler block
cannot be assembled as a complete unit.
For installation of boiler supplied fully assembled
(
Æ
Chapter 7.3, page 36).
Fig. 4
Boiler block in the assembled state
1
Foundation/installation location
2
Drain
3
Back section
4
Flue outlet
5
Connecting block
6
Central sections
7
Anchor rods
8
Burner door
9
Front section
5.1
Assembly when delivered in sections
B
Assembly all boiler sections in accordance with the
following instructions and diagrams.
5.1.1
Preparing boiler sections
B
Position the rear section onto two wood blocks.
B
Clean the boiler hubs with sandpaper and a rag.
B
Remove any burrs with a file.
B
Clean the packing spring or packing groove with a
wire brush and rag.
Fig. 5
Remove burrs
1
Boiler hubs
2
Sealing spring
3
Back section
4
Wood blocks
B
Clean the hub sealing faces with a rag soaked in
cleaning agent.
CAUTION:
Risk of injury by not securing the
boiler adequately during transport.
B
Use only suitable means for
transportation, e.g. a trolley with strap, a
stair or step trolley.
B
Secure the load against falling.
6 720 648 032-04.1T
8
9
7
1
2
3
4
5
6
7
CAUTION:
Risk to health or danger of burns
due to released vapors and easily flammable
cleaning agents.
B
When using red lead putty, adhesives and
solvents ensure adequate ventilation
inside the installation room.
B
When using solvents, avoid open flames,
incandescence and sparks.
B
Please observe the manufacturer‘s
handling and safety instructions.
1
4
2
1
3
6 720 648 032-05.1T