Bosch TES502 series, Instruction Manual

Page: 20 / 132

16
en
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
Cleaning
Duration: approx. 10 minutes.
Important: Clean the brewing unit before
starting the service programme, see chapter
“Cleaning the brewing unit”.
If the message
Clean required!
appears
on the display, press the
e
off /
j
button
(12) for 3 seconds and then press the start
button (10).
The cleaning programme will start.
To clean the appliance before being
prompted, press the
e
off /
j
button (12) for
at least 3 seconds. Then press the
e
off /
j
button (12) briefly twice. Turn the upper
rotary knob (14) until
Start cleaning
appears in the display.
To start the cleaning procedure, press the
start button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Cleaning in progress
The appliance rinses twice.
Open drawer
● Open the drawer (4).
Fill cleaner
● Drop a Bosch cleaning tablet in the
drawer (4) and close.
Cleaning in progress
The cleaning pro gramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
The appliance has finished cleaning is
ready for use again.
Calc’nClean
Duration: approx. 35 minutes.
Calc’nClean combines the separate func-
tions of descaling and cleaning. If both
programmes are due to be run soon, the
espresso machine automatically suggests
this service programme.
Important: If there is a filter in the water
tank (16), it needs to be removed before
the service programme is run. Clean the
brewing unit before starting the service
programme, see chapter “Cleaning the
brewing unit”.
If the message
Calc’nClean required!
appears on the display, press the
e
off /
j
button (12) for 3 seconds and then press
the start button (10). The service pro-
gramme will start.
To run Calc’nClean before being prompted,
press the
e
off /
j
button (12) for at least
3 seconds.
Then press the
e
off /
j
button (12) briefly
twice. Turn the upper rotary knob (14) until
Start Calc’nClean
appears in the display.
To start Calc’nClean, press the start button
(10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Calc’nClean in progress
The appliance rinses twice.
Open drawer
● Open the drawer (4).