Bosch TES502 series, Instruction Manual

Page: 15 / 132

11
en
Preparing milk froth
¡
Risk of burns!
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk first and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use with
the cleaned milk frother attached.
1. Press the
h
button (11).
The
h
button (11) flashes and the
appliance now heats up for approx.
20 seconds. The display then shows
Pull milk frother
.
2. Immerse the milk frother so that it
reaches the bottom of a cup or glass
that is one-third filled with milk.
3. Pull the milk frother (6) to open it.
¡
Risk of scalding!
Splashes of milk can scald. Do not touch
the outlet (6a) or aim it at anyone.
4. Close milk frother (6) by pushing it in.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the
Rinse milk
system
programme).
Maintenance and
daily cleaning
¡
Risk of electric shock!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
soft, damp cloth.
● Do not use abrasive cloths or cleaning
agents.
● Always remove any limescale, coffee,
milk or descaling fluid residue immedi-
ately. Such residue can cause corrosion.
● New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
● Pull the drip tray (8c) with the coffee
grounds container (8b) forward and out.
Remove the panel (8a) and the grate
(8d). Empty and clean the drip tray and
coffee grounds container.
Remove drawer (4) and clean.