Bosch SE3000 Series, Hardware Installation Manual

Page: 31 / 40

Security Escort System power-up and debug | en 31
Robert Bosch (SEA) Pte Ltd Hardware Installation Manual 2018.03 | SE3v1.0 | DOC
7. To verify the RF reception, LED and sounder operation, and location of each SE receiver,
select the menu
Setup > Receiver configuration . The following dialog window appears:
8. Select the desired SE coordinator from the Transponder drop-down list box.
– Click the [?] button next to the point number field. A grid of bus and point numbers
appears showing the programmed SE receivers.
– Click the lowest point number button. If the first SE receiver is MUX point zero (0),
click the
[0] button. If the first SE receiver is point one (1), click the [1] button. The
point number is automatically entered.
– Click the [Put this receiver in setup mode] button. The red and green LED light up
for the selected SE receiver on the selected SE coordinator.
– Take the maintenance SE transmitter and go to the selected SE receiver. The red and
green LED should be lit when you arrive at the first SE receiver location.
– Transmit an alarm from the maintenance SE transmitter. The SE receiver should
activate by flashing the red LED and activate the sounder (if the sounder jumper is in
place on the SE receiver). This confirms that the RF portion of the SE receiver is
working and you are at the right location. The software then turns off the LEDs on
the tested SE receiver. The SE receiver with the next higher point number is
automatically selected and its red and green LED lights up.
– Proceed to that SE receiver and perform the same operation with an alarm on the
maintenance SE transmitter until the operation of all SE receivers is confirmed and
all SE receivers are working and in their proper location on that SE coordinator. If
the LED fails to light up, the LED jumpers may be missing on that SE receiver, the SE
receiver may be set to the wrong address, or you may be at the wrong location. If the