38
en | RADION universal transmitter
RADION receiver OP
2014.12 | 02 | F.01U.261.835
Reference Guide
Bosch Security Systems, Inc.
3 * 1.5 k Ω alarm EOL
4 * 2.2 k Ω tamper EOL
5 * Input disabled – no contact, 2.2 k Ω EOL
12.1
Installation considerations
You have a variety of installation options to consider when installing the device. You must
acknowledge the unique installation approach prior to installation. Some installation
considerations include:
–
The location of the magnet and transmitter in relationship to the door/window frame
dimensions. Verify you have proper clearance with the latch of the window or door you
are installing the device onto. Failure to do so will make it extremely difficult to access
and open the device for maintenance purposes.
–
In some cases, you might need an additional spacer when installing the transmitter and
magnet in the corner of a recessed door or window frame to close the gap in height
between the magnet and transmitter.
–
On surface areas that are not conducive to mounting via the screws, you can secure
transmitters and magnets using an industrial strength adhesive.
–
When installing the magnet, verify that the notches in the magnet base, line up with the
notches in the transmitter base, otherwise the magnet and transmitter do not function
effectively.
–
When installing the magnet base, install the face of the magnet base flush to the surface
edge of the installation location. This prevents damage to the magnet plastic base
whenever a window or door is opened.
–
Adhere to the distances prescribed in the graphical table found in the graphical
Installation and Operation Guide
when installing the magnet adjacent to the transmitter.
How to read the Graphical Magnet Distances table
Contained in the universal transmitter
Installation and Operation Guide
is a graphical table
along with the
X
*
Y
*
Z coordinates graphic. Use the table in conjunction with the graphic to
determine desired distances between the magnet and the transmitter based on the type of
installation (wood or metal).
Notice!
The content in the graphical table applies to EN installations.
12.2
Reed switch settings
Set the detector to enable or disable the reed switch.
Notice!
Please note, insert the jumper onto the pin prior to installing the battery. Failure to do so may
result in unexpected operation of the device.
Summary of Contents for RFRC-OPT
Page 1: ...RADION receiver OP RFRC OPT en Reference Guide ...
Page 2: ......
