Bosch RFRC-OPT, Reference Manual

Page: 15 / 52

RADION receiver OP RADION receiver OP | en 15
Bosch Security Systems, Inc. Reference Guide 2014.12 | 02 | F.01U.261.835
3.3.8 RFRC-OPT system test
Overall system test
It is recommended by to test the entire system at least once every year, including the RFRC-
OPT receiver by an installer to ensure proper functionality of the RADION system.
3.4 External LED states
The receiver utilizes the External LED to show various states of the receiver. These states fall
into the following three categories:
–
Normal state
– Communication error state
– Trouble state
– Maintenance state
– Off state
Normal state:
The receiver enters a normal state when it has passed all power self-tests and has established
a communication link with the control panel . The receiver remains in this state as long as the
communication link is present, and no other issues are present that would prevent the
receiver from operating in a normal condition.
LED condition State description
On (Normal) Indicates the receiver is functioning normally.
Continuous slow flash: 1 sec On, 1 sec Off Indicates the receiver is being programmed
with the zone and transmitter ID’s from the
compatible control panel.
Turns Off momentarily Indicates the receiver obtained a valid
transmission from a RADION transmitter.
Flash 3 times Indicates the receiver has obtained a new
device ID while in “Learn Mode.”
Communication error state:
The receiver enters a communication error state when, during power up, it does not establish
a link with the control panel, or has been in an idle state for more than 30 sec without
communication. Another cause for a communication error state is an invalid address switch
setting (0, or 9).
LED condition State description
3-pulse flash: A 3-pulse signal, followed by a
short delay at the end of the 3
rd
pulse
(Communication error)
Indicates the receiver has experienced a
communication failure. This error could be a
result of either:
–
A communication failure between the
control panel and receiver, or
– An invalid address switch setting