NOTICE
In the event of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Hints are represented as follows:
This is an information.
Tips are represented as follows:
This is a tip.
3.4 Signal graphic explanation on the device
krax
Prior to the installation and commissioning of the device, refer to the
device documentation.
4 Intended use
The Bosch Rexroth Embedded Terminals are PC based machine operator termi-
nals. Depending on the respective configuration they can also perform control
functions. The products are designed for use in industrial environments.
Danger of destruction of the device if not ex-
pressly stated accessories, mounting parts and
other components, cables, lines, software and
firmware are used.
NOTICE
The Embedded Terminals may be used only as intended and with the accesso-
ries, mounting parts, and other components specified in this documentation.
Components that are not expressly mentioned must neither be attached nor
connected. The same is valid for cables and lines.
Operation must only be carried out with the hardware component configura-
tions and combinations that are expressly specified and with the software and
firmware indicated and specified in the respective documentation and functional
descriptions.
Embedded Terminals with Profibus DP
Master
Bosch Rexroth AG
Intended use
DOK-CONTRL-VEP*XX.5***-IT01-EN-P
5/41