20 / 36
IndraControl XFE 01.1
Dismounting
Bosch Rexroth AG
R911345570, Edition 06
A
B
D
C
Fig. 9: Interconnect extension bus base modules and connect them to the control bus base module
10.4 Dismounting
To dismount, use a common tool such a slotted screwdriver with a 2.5 mm blade.
NOTICE
Destruction of components and devices due to mounting and dismounting
under voltage!
−
Before mounting or dismounting, disconnect the control - including its
components - from voltage.
−
Connect the voltage only after the control and its components have been
set up.
10.4.1 Removing extension module from top-hat rail
1.
Remove the left end clamp.
2.
Use a suitable tool (e.g. slotted screwdriver) and put it first into the upper and then into the
lower disengaging mechanism (base latch) of the control and disengage the control (see (A) in
the following figure). The base latches are locked in the open position.
3.
Remove the extension module vertically to the mounting rail (see (B) in the following figure). The
base latches engage again in idle position.
