Rexroth Diax 04 HDD and HDS
Instructions for Use
5-9
DOK-DIAX04-HDD+HDS*UL*-IB01-EN-P
The entire shield of the motor cable is mounted to shield attachment XS1
using the enclosed clamp fitting. It is matched to the diameter of the cable
by simply selecting the relevant clamp base on the mounting panel. The
cable output direction can be either horizontal or vertical and is achieved
by adjusting the mounting panel.
Note:
Always connect shield of cables with a large metal-to-metal
contact surface to shield connection.
For cable cross-sections greater than 25 mm² you can use a special
mounting plate as shield attachment. The following figures show the
mounting plate at the drive controller. You can mount the mounting plate
horizontally or vertically at the drive controller.
Ap5415f1.fh7
mounting plate
Fig. 5-15:
Mounting plate for cable cross-sections greater than 25 mm
2
Fig. 5-16:
Vertically arranged mounting plate
Connector XS1, shield
attachment of motor cable
