English– 8
1 609 929 J60 • (05.12) PS
Mounting of the Extension Hoops
(see Figure
)
Mounting the Saw Table Extension and
Length Stop
The saw table extension
5
and the length stop
38
can
be positioned on the left or right of the power tool.
Insert the saw table extension and the length stop as
required on the appropriate extension hoop
6
and
tighten the respective winged nut.
Attaching the Extension Hoops
For attachment, use the "extension hoop" attachment
set
39
(two U6profiles with screws).
Tip over the power tool so that the extension hoop can
be attached on the underside of the machine.
Hold a U6profile over an attachment piece on the
housing
40
so that the drillings in both pieces are
aligned.
Slide the extension hoop to the stop through the drill6
ings
16
, the U6profile and the attachment pieces on
the housing.
Tighten the screw in the U6profile to secure the exten6
sion hoop.
Repeat the work steps for the second extension hoop
on the other side of the power tool.
Mounting the Locking Knob
(see Figure
)
Screw the locking knob
12
into the threaded hole be6
low the lever
11
.
Do not tighten the knob too firmly.
Inserting the Batteries
(see Figure
)
Open the battery compartment
30
.
Insert the batteries provided according to the polarisa6
tion indicated.
Close the battery compartment.
Stationary Mounting
To ensure safe handling, the power tool
must be mounted on a flat and stabile
working surface (e.g., workbench).
Mounting without the Table Stand
(see Figure
)
Attach the power tool with suitable screw fasteners to
the working surface. The holes
15
serve for this pur6
pose.
Mounting with the Table Stand
(see Figure
)
Use the "Table Stand" attachment set
42
for mounting
(24 screws with nuts for assembly, 4 screws with nuts
for attachment to the power tool, 4 washers).
Screw together the table stand
41
. Tighten the screws
firmly.
Attach the power tool to the support surface of the ta6
ble stand. The drillings
15
on the power tool as well as
the elongated holes in the table stand serve for this
purpose.
5
OPERATING INSTRUCTIONS
Transport and Working Positions
(see Figure
)
Before all work on the machine, pull the mains
plug.
The transport locking pin
27
makes possible easy han6
dling of the machine when transporting to the various
working locations.
Securing the Machine (Transport Position)
Tighten the locking knob
12
to lock the saw table
14
.
Press the knob
1
(also see Figure
) and, at the same
time, swing the tool arm downward with the handle
2
.
Pull the transport locking pin
27
completely out and
turn by 90°. Allow the transport locking pin to engage
in this position.
The tool arm is now securely lock for transport.
Releasing the Machine (Working Position)
Press the tool arm with the handle
2
downward some6
what to relieve the load on the transport locking pin.
Pull the transport locking pin
27
completely out and
turn by 90°. Allow the transport locking pin to engage
in this position.
Guide the tool arm slowly upward.
A
B
C
D
E
F
M
PCM10_WEU.book Seite 8 Donnerstag, 1. Dezember 2005 9:16 09