MON172CL20
Installing the MON172CL20 | en
5
Bosch Security Systems, Inc.
Instruction Manual
F01U064552 | 1.0 | 2007.02
4
Installing the MON172CL20
This chapter outlines the procedures needed to install the MON172CL20 Series. Installation
should be made by a qualified service person and all local codes should be conformed to.
4.1
Mounting the MON172CL20
The MON172CL20 is designed to be used for desktop, wall, or rack mounting.
4.1.1
Desktop Installation
The MON172CL20 monitor is delivered with a 3-pole US-style power cord and a 3-pole Euro-
style power cord. Use the US-style power cord where 120 VAC, 60 Hz power is available; and
use the Euro-style power cord where 230 VAC, 50 Hz power is available. The monitor automat-
ically adjusts to either power input voltage. A Power (ON/OFF) switch is located on the base
of the unit.
4.1.2
Wall Mount Installation
The square mounting holes (100 mm (3.9 in.) centers) can be used for rack mount installation
(refer to the MON171RK Rack Mount Kit Instructions or with wall mount brackets (not pro-
vided). To install the wall mount, do the following:
1.
Remove the MON172CL20 power supply/base from the LCD panel section by unscrewing
the two (2) holding screws before separating the base from the panel, as shown in
Figure 4.1
on page 5.
Fig. 4.1
Removing the Base
