14
en | Navigating the Monitor
MON172CL20
F01U064552 | 1.0 | 2007.02
Instruction Manual
Bosch Security Systems, Inc.
5.3
Navigating the Monitor On-screen Display (OSD)
The MON172CL20 has two (2) modes, Video and VGA. The MON172CL20 is programmed
through the on-screen display (OSD) menus. Each on-screen display (OSD) shows a list of
parameters or submenus that can be selected by the operator. To access the OSD menus,
press the Menu button. Use the front panel of the MON172CL20 to make any necessary
adjustments to the OSD. To navigate the set up menus, follow the steps below:
1.
Connect the CVBS, VGA, or DVI cable.
2.
If required, press the Input button until a signal is displayed. NOTE: Menus are not avail-
able without a signal applied.
3.
Power on the unit by pressing the power button (see
Figure 5.1
on page 13).
4.
Press the Menu button to activate the main menu selections (see
Figure 5.1
on page 13).
5.
Press the
and
buttons to navigate in selecting a main menu.
6.
Press the Menu button to enter into the selected main menu.
7.
Press the
and
button to toggle the OSD values.
When finished, scroll down to Exit and press the Menu button. NOTE: If there is no Exit but-
ton, press the Menu button.
