Bosch KDD Series, Instructions For Use Manual

Page: 48 / 136

en
48
Fault Possible cause Remedial action
The appliance displays a
temperature alarm for no
apparent reason.
A heat source is located too
close to the appliance.
A second refrigerator is
located right next to the
appliance (side-by-side
installation).
Call customer service.
The light does not function. The LED light is defective. See chapter “Light (LED)” section.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is closed and opened,
the light is on again.
Displays do not illuminate. Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
The evaporator (refrigeration
generator) in the
NoFrost system is covered
in thick ice and can no
longer be defrosted fully
automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan,
at the rear of the appliance.
To prevent the evaporation pan
from overflowing in this case,
mop up the condensation with a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Condensation accumulates
on the surface of the
appliance and on the shelves
inside.
The effect is reinforced if
ambient temperatures are
warm and humid.
Wipe away the water with a soft, dry cloth.
■
Open the appliance as briefly as possible
■
Make sure that the appliance is always
closed properly.