-14-
To select the reference point,
push button
1
repeatedly until the
required reference point is
indicated in the display. Each
time after switching on, the rear
edge of the rangefinder is preset
as the reference point.
Changing the Unit of Measure
The unit of measure can be
changed any time for display of
the measured values, even for
already measured or calculated
values.
For display of the current length
measurement values, the units of
measure shown above are
available.
Area and volume values as well
as stored measured values can
only be displayed in “ft” or “m”.
To change the unit of measure,
push button
13
until a new unit of
measure is displayed.
The unit-of-measure setting is
retained when switching the
rangefinder on or off.
Continuous Laser Beam
If required, the rangefinder can
be set so that the laser beam
stays on in between
measurements. For this, Briefly
push button
13
. The indication
“
LASER
” lights up continuously
in the display.
Do not point the
laser beam at persons or
animals and do not look into
the laser beam yourself, not
even from a large distance.
In this setting, the laser beam
also remains switched on
between measurements; to take
measurement, it is only required
to push the measuring button
10
once.
To switch off the continuous laser
beam, briefly push button
13
again or switch the rangefinder
off. When switching on again, the
rangefinder is in the normal
operation; the laser beam only
appears when pushing the
measuring button
10
.
MEASURING MODES
Length Measurement
For length measurements, push
button
5
until the indicator for
length measurement
appears in the display.
Press the measuring button
10
once for sighting and once more
to take the measurement.
The measured value is indicated
at the bottom in the display.
!
WARNING
