114
4.50
208
8.18
471
18.54
100
3.94
381
15.01
90°
Figure 3.3: Side view
Initial Preparations
The camera transmits zoom control commands and images over a TCP/IP network. It also
allows users to configure the camera display settings, camera operating settings, and to
configure the network parameters.
The camera incorporates a network video server in the IP module. The primary function of the
server is to encode video and control data for transmission over a TCP/IP network. With this
H.264 encoding, it is ideally suited for IP communication and for remote access to video
management systems. The use of existing networks means that integration with CCTV systems
or local networks can be achieved quickly and easily. Video images from a single camera can
be simultaneously received on several receivers.
–
Determine the operating voltage at the installation site. The unit can receive an input
voltage range of 24 VAC ± 10%/HPoE without damage.
–
All units have been tested prior to shipment. It is advisable to check the unit’s operation
before installation.
!
Caution!
It is recommended that the installer wear an ESD strap or discharge any static electricity to
ground before handling any electronic components.
Notice!
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
unit housing is open. Bosch recommends that the unit housing be open for no more than five
(5) minutes.
3.2
16
en | Planning
EXTEGRA IP 9000 FX
2016.02 | 1.2 | F.01U.319.357
Installation Manual / Guide d'installation
Bosch Security Systems
