Bosch EXTEGRA IP 9000 FX, Operation Manual

Page: 36 / 54

Aux Off: defines a standard or custom keyboard OFF command. Refer to to User
Command Table for a list of valid commands.
Note: Only commands 1, 8, 18, 20, 43, 60, 80, 86 are supported. Support for the
remaining commands is scheduled for a future release.
Shot: defines a preset scene from shot 1-256.
4. Click Set to save and to activate the alarm rules.
Advanced Mode: Interfaces
Alarm Inputs, page 36
Alarm Outputs, page 36
Alarm Inputs
Select the type of input for each physical alarm. Select from either N.O. (Normally Open) or
N.C. (Normally Closed) and provide an optional name for each input.
Alarm Outputs
The camera incorporates three (3) open collector alarm or transistor outputs. Use the
following settings to configure the relay for alarm outputs.
Idle state
Specify either Open or Closed idle state.
Operating mode
Select one of the following modes for operation: Bistable, 0.5 s, 1 s, 5 s, 10 s, or 60 s.
Output name
Type an optional name for the relay connection, up to 20 characters.
Trigger output
Click the appropriate Trigger output button to test the relay / output connection.
Advanced Mode: Network
Network Access
DynDNS, page 36
Advanced, page 37
Network Management, page 38
Multicast, page 38
Image Posting, page 39
Accounts, page 40
IPv4 Filter, page 40
Encryption, page 41
DynDNS
Enable DynDNS
DynDNS.org is a DNS hosting service that stores IP addresses in a database ready for use. It
allows you to select the camera via the Internet using a host name, without having to know the
current IP address of the unit. You can enable this service here. To do this, you must have an
account with DynDNS.org and you must have registered the required host name for the unit on
that site.
Notice!
Information about the service, registration process and available host names can be found at
DynDNS.org.
5.33
5.34
5.35
5.36
5.37
36 en | Configuration via IP, Advanced Mode EXTEGRA IP 9000 FX
2015.03 | 1.0 | Operation Manual Bosch Security Systems