48
en | Configuration
FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
2020-01 | V02 | DOC
User manual
Bosch Security Systems B.V.
User name
Enter the user name you registered.
Password
Enter the password you registered.
Force registration now
Force the registration by transferring the IP address to the DynDNS server. Entries that
change frequently are not provided in the Domain Name System. It is a good idea to force the
registration when setting up the device for the first time. Only use this function when
necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the device, click the
Register
button.
Status
The status of the DynDNS function is displayed here for information purposes; these settings
cannot be changed.
Click
Set
to apply the changes.
4.7.4
Advanced
Cloud-based services
Operation
The operation mode determines how the camera communicates with Cloud-based Security
and Services.
–
Select
Auto
to allow the camera to poll the server a few times; if no contact is made, it
stops polling.
–
Select
On
to constantly poll the server.
–
Select
Off
to block polling.
Cloud state
This field identifies any cloud-based services with which the camera communicates.
–
If you have registered the device on a cloud-based service such as Bosch Remote Portal,
then this field identifies this fact (“
Registered on Bosch Remote Portal
”).
Note
: The button (
Connect to Bosch Remote Portal
) to connect to the device with that
service is active.
–
If you have not registered the device, then the message, “
Not running
.
(Automatic IP
assignment not active)
“ appears.
Note
: The button (
Connect to Bosch Remote Portal
) to connect to the device with that
service is not active.
Stratocast
Enter the Stratocast
Registration code
to connect with the Genetec’s Stratocast cloud.
Click
Register
to activate the account.
RTSP port
If necessary, select a different port for the exchange of the
RTSP
data from the list. The
standard
RTSP port
is 554. Select
Off
to deactivate the
RTSP
function.
Authentication (802.1x)
To configure Radius server authentication, connect the unit directly to a computer using a
network cable. If a Radius server controls access rights over the network, select
On
to activate
authentication to communicate with the unit.
1.
Enter the user name that the Radius server uses for the unit in the
Identity
field.
2.
Enter the
Password
that the Radius server expects from the unit.
