9
If you encounter a problem
If an
#
appears in the display:
❑
See "Filters and maintenance" Section.
If is not possible to operate the extractor
hood:
❑
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box.
Wait for approx. 1 minute and then
switch it on again.
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
E-Nr. FD
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
IMPORTANT:
The manufacturer of the extractor hoods
accepts no liability for complaints which
can be attributed to the design and lay-
out of the pipework.
4.
Re-insert the bulb ring.
5.
Plug the appliance into the mains or
switch it on at the fuse box.
NOTE:
If the light does not function, check that the
bulbs have been inserted correctly.
Replacing the light bulbs
3.
Replace the halogen light bulb
(conventional halogen bulb, 12 Volt,
max. 20 Watt, G4 cap).
NOTE:
Refer for plug-in lampholder.
Take hold of the bulb with a clean cloth.
1.
Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
CAUTION:
When switched on, the halogen bulbs
become very hot. Even for some time after
the bulbs have been switched off there is
still a risk of burns.
2.
Remove the bulb ring with a screwdriver
or similar tool.
Summary of Contents for DIE 165 R
Page 2: ...2 en page 03 16 fr pages 17 30 es página 31 44 Abb 1 ELECTRO Fig 1 GAZ ...
Page 45: ...45 Notes ...
Page 46: ...46 Notes ...
Page 47: ...47 Noticias ...
