54
▶ Crown Molding Auxiliary Fence
When
making
a
compound
cut
on
a
molding lying flat on the table, narrow cut-
off pieces (2" or less in width) may be
propelled at high speed over the fence and
beyond the back of the tool (see Figure 59).
Use auxiliary fence as instructed and shown
in figures below.
Figure 59. Cut-off Piece Over Fence
An auxiliary fence is used to add support to
the cut-off workpiece such as large crown
molding when cut flat on the table (see Figure
60). It will reduce splintering and movement
of the unsupported cut-off piece of wood
after the cut is made.
Figure 60. Cut-off Piece Stopped by
Auxiliary Fence
Making an Auxiliary Fence:
Required pieces:
Wood Board (described below)
4 – Flat Head Machine Screws – 1/4" diameter;
2-1/2" long
4 – 1/4" Flat Washers
4 – Nuts
1.
Cut a nominal 1" x 2" wood board to a length
of 26-1/16" long. NOTE: 1 x 2" nominal
equals 3/4" x 1-1/2" actual. 3/4" plywood
cut to size may be substituted.
2.
Drill four holes through the board using a
5/16" diameter drill bit. Countersink the
holes deep enough so that the flat head
screws will rest below the front work
surface – use a 1/2" diameter drill bit (see
Figure 61).
Remove the sliding fences from the tool – see
page 34.
1.
Place the flat head screws through the holes
in the auxiliary fence, then the holes in the
stationary fence on the tool.
2.
Place the washers and nuts over the screw
threads and against the stationary fence.
Tighten nuts.
First-Time Use of the Auxiliary Fence:
NOTE: The first time the auxiliary fence is
used, it will be cut through by the saw blade
– cutting through creates minimal clearance
which reduces splintering on the workpiece.
Set the miter angle and the bevel angle
required before making the first cut. Clamp
the workpiece, then make cut – example:
compound cutting large crown molding flat on
the table (see Figure 58).
Be aware of the path of
the saw blade. Make a
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep hands
at least six (6) inches away from the
projected path of the saw blade.
Small Cut-off Piece
Stationary Fence
Auxiliary Fence
Small Cut-off Piece
Saw Operations
2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 54