12
23. Rubber Deflector
– Attaches to bottom of chute.
Deflects dust into the chute.
24. Dust Chute
– Directs sawdust up and through the
elbow and to the bag.
25. Elbow
– Connects the dust chute to the dust bag.
Can be rotated to direct dust.
26. Dust Bag
– Has a zipper at the bottom. Bag can be
uncoupled from elbow for emptying.
27. Mechanism Lock Lever
– Holds saw in full back
position for chop cuts or fully extended for
transporting.
28. Link Knob
– Attaches guard link to the pivot post.
29. Lower Guard Link
– Allows for smooth movement
of the lower guard.
30. Clamp
– Use to hold the workpiece to the table
and base – insert into clamp post location (item
39).
31. Brush Cap
– Keeps motor brushes in position.
Provides access for inspecting and replacing
brushes.
32. Depth Stop Screw
– Turn the knob end to adjust
the blade depth for cutting grooves.
33. Depth Stop Plate
– Plate can be swung out to limit
the depth of the blade travel.
34. Pivot Post
– Provides support for the saw head,
dust collection system and other functional parts.
35. Axial Glide Mechanism
– Allows saw to smoothly
slide in and out. Can be locked in full rear or fully
extended positions.
36. Bevel Scale and Pointers
– Scale is large and
angled - allows user to easily read bevel angles.
Pointer indicates what the current angle is.
37. Bevel Post
– Provides rotating support for all
miter saw parts above the table.
38. Bevel Detent Pin (Crown Molding Setting)
–
When engaged, it locks the head assembly to the
bevel angle of 33.9° to the left or right.
39. Fence Lock Knob
– Secures fence in desired
position.
40. Miter Detent Plate Screws
– Four screws
accessible through holes in the miter scale. These
screws are loosened when adjusting position of
the detent plate.
41. Bevel Range Selector Knob
– Allows selection of
3 bevel ranges: “0-45° Left”, “0-45° Right” or “Max.
Bevel Angle to 47°.”
42. Arbor Lock
– Press arbor lock button to keep
blade from rotating when loosening or tightening
arbor bolt during blade removal or installation.
43. Head Assembly Lock Pin
– Used to lock the head
assembly in the lower position for transporting.
44. Glide Movement Controller
– Adjusts to regulate
movement of the glide mechanism.
45. Base Extension Lock Levers
– Locks the base
extensions at the desired positions.
46. Crown stop mount holes
– For attaching optional
crown stop supports, see page 61.
34
32
35
36
37
38
39
40
41
43
10
33
42
44
22
45
46
Getting To Know Your Miter Saw
2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 12