28
▶ 45° Bevel Stop – Adjustment
Procedure
To avoid possible injury,
disconnect plug from
power
source
before
performing
any
assembly, adjustments or repairs.
▼ ADjUSTING 45° BEVEL STOP
(SAW BLADE 45° TO TABLE)
1.
Pull up the bevel lock lever to unlock. Move
the left sliding fence fully to the left.
2.
Tilt
the
saw
assembly
to
the
left
(counterclockwise) until it hits the 45° stop.
3.
Place only the combination square’s head
on the saw’s table with its long flat side
resting on the table and its 45° side against
the tilted blade.
4.
Place an 8mm open end wrench on bolt
head “F” (see Figure 25).
5.
While turning bolt “F,” watch the blade tilt –
turn “F” until the saw blade plate is in full
contact with the 45° side of the square’s
head (see Figure 24).
6.
If needed, adjust bevel scale pointers (item
36 – page 12) to be in line with the bevel
scale’s 45° lines. First, adjust right bevel
pointer; then tilt saw head to the right 45°
stop position (see page 45 – “Bevel Range 2
= 0-45° Right”) and adjust the left bevel
pointer. Tilt the saw head to the 0° position
– both pointers should be on the bevel
scale’s 0° lines.
7.
Push down the bevel lock lever to lock at
the desired bevel angle.
Figure 25
Adjusting Bevel Stops
Adjustments
2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 28