9
Conduct an inspection of the intendant installation position and ensure that the
panels can be fitted in this position prior to commencing any work.
1. Position the lower bracket on the roof ensuring there is sufficient room to fit the panels.
2. Remove the row of tiles above the bracket position.
3. Loop bracket support strap through the bracket and fix bracket support to the roof
rafters, Ensure the bracket is level.
4. Flatten out return of bracket strap
5. Bend all bracket straps to fit over tiles.
6. Replace tiles above the bracket
7. Unpack panels (where fitted remove protective plastic from the panels)
8. Place panels into position and fit against lower bracket
9. Join the panels together using the brass barrel unions supplied in the panel installation
kit.
10. Centre the panels onto the lower bracket and secure the panels onto the bracket 20mm
above the bottom of the bracket using the hex screws supplied.
Warning
: Do not drill
above 20mm from the bottom of the bracket, as this may cause damage to the internal
workings of the panel and this will void the warranty.
11. Remove the row of tiles above the panels to enable the upper bracket to be fitted.
12. Loop bracket support strap through the bracket, Flatten out return of bracket strap
13. Secure bracket to panels 20mm above the bottom of the bracket using hex self-drilling
screws. Warning: Do not drill above 20mm from the bottom of the bracket as this may
cause damage to the internal workings of the panel and this will void the warranty.
14. Fix bracket support strap to the roof rafters.
15. Bend all bracket straps to fit through and over tiles.
