34
en | RADION receiver SD
RADION receiver SD
2020.05 | 13 | F.01U.261.834
Bosch Security Systems B.V.
On (Normal)
Indicates the receiver is
functioning normally.
Continuous slow flash: 1 sec
On, 1 sec Off
Indicates the receiver is being
programmed with the zone
and transmitter ID’s from the
compatible control panel.
Turns Off momentarily
Indicates the receiver
obtained a valid transmission
from a RADION transmitter.
Flash 3 times
Indicates the receiver has
obtained a new device ID
while in “Learn Mode.”
Communication error state:
The receiver enters a communication error state when, during
power up, it does not establish a link with the control panel, or
has been in an idle state for more than 30 sec without
communication. Another cause for a communication error state
is an invalid address switch setting (0, or 9).
LED condition
State description
3-pulse flash: A 3-pulse signal,
followed by a short delay at
the end of the 3
rd
pulse
(Communication error)
Indicates the receiver has
experienced a communication
failure. This error could be a
result of either:
–
A communication failure
between the control
panel and receiver, or
–
An invalid address switch
setting
