AUTODOME inteox 7000i - 2MP (in-ceiling)
Installing the In-Ceiling Mount | en
19
Bosch Security Systems
Installation Manual
2021-08 | 1.4 |
4
Use the bracket Base Plate as a template or cut a hole-sized hole in the center of the
ceiling tile with a drywall utility saw or jig saw.
4
Tighten the four (4) securing screws to the Bracket Assembly.
4
Secure the Bracket Assembly to an overhead securing point with a safety wire.
7.5
Installing the Ceiling (IP54 Housing) Gasket
In order to conform to the IP54 rating, you must install the ceiling gasket, illustrated (along
with the other pieces that protect the camera and provide the IP54 rating) in the figure below.
In addition, if you are using the optional black trim ring instead of the factory-installed white
trim ring, the trim ring gasket must also be in place to provide the IP54 protection. (Refer to
Replace the trim ring (optional) (In-ceiling models) for step-by-step installation instructions.)
1
2
3
4
5
Figure 7.2:
In-ceiling (IP54 Rating) Installation Diagram
1 White Trim Ring (factory-installed on
dome bubble)
5 Inner Ring
2 Black Trim Ring (supplied in the
shipping box of the camera)
6 Ceiling (IP54 housing) Gasket
3 Bubble
7 In-ceiling housing
4 Trim Ring Gasket
1.
Place the gasket (provided in the shipping box of the camera) over the top of the in-
ceiling housing.
2.
Carefully slide the gasket down over the housing, until it rests on the flange of the
housing.
Summary of Contents for Autodome Inteox 7000i-2MP
Page 1: ...AUTODOME inteox 7000i 2MP in ceiling en Installation Manual ...
Page 2: ......
Page 43: ......
