BOS Suspension Factory Series, Service Manual

Page: 26 / 32

26

Apply a dot of copper grease on the thread of the rod guide

Screw the cap in the rod guide

Apply a 35 Nm torque on the cap

Apply a drop of Loctite 243 to the grub screw

Screw it into the cap with a torque of 2Nm
SPRING REASSEMBLY

Finally, put the spring back on your shock absorber

Position the snap ring and the cup

Apply the spring preload and the compression and rebound settings found before disassembly. If you
forgot your values, refer to your motorcycle manual to perform your SAG and apply the
recommended compression and rebound settings
Required tools :
-
Copper grease
Required tools :
- By hand
Required tools :
- Rod guide tool
(
42312-O-012)
-
32mm fork tip
(
390115-O-024A)
- Torque wrench
Required tools :
- 3mm Allen key
- Loctite 243