10/19
CH18FT
Made in China to TQB Brands Pty Ltd specifications
P a g e
| 7
Visit us at www.tqbbrands.com.au
Quill Spring Adjustment
Fig 17 Speed Adjustment
1.
Move the stop nuts to the lowest position and lock
into place with a wrench to prevent quill dropping
while tensioning spring
2.
Place screwdriver in lower front notch (A) of spring
cap (B) and hold it in place while loosening and
removing nuts.
3.
Carefully turn screwdriver counter clockwise and
engage next notch
4.
Tighten inner nut (C) with wrench. DO NOT
overtighten as this will restrict quill removal.
5.
Move stop nuts to highest position and check
tension while turning feed handle. It there isn’t
enough tension on spring, repeat steps 2 – 4.
6.
Check quill while feeding for: Smooth and
unrestricted movement. If movement is too tight
slightly loosen nuts until unrestricted.
3.
BEFORE USE
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked welds,
leaks, and damaged, loose, or missing parts.
Caution:
This drill press is intended for use only with drill bits. The use of other accessories
may be hazardous.
Drill Speed: Factors that determine the best speed to use in any drill press operation are:
Type of material being worked on, size of hole, type of drill or cutter and quality of cut
desired. The smaller the drill bit, the greater the required RPM. For softer materials,
the speed should be higher than firmer material.
Drill Metal: Use clamps to hold work in place when drilling metal. DO NOT hold with hand. The
flutes of the drill may seize the work at any time, especially when breaking through
stock, causing the work piece to spin.
Clamp:
The work must be clamped firmly while drilling: Any tilting, twisting, or shifting results
not only in a rough hole, but also increases drill bit breakage. For flat work, lay the
piece on a wooden base and clamp firmly down against the table to prevent the work
piece from turning. If the piece is of irregular shape and cannot be laid flat on the
table, is should be securely blocked and clamped.
Chuck:
The chuck should be securely fastened to the spindle. Remove the chuck after
adjustment. Only use the chuck key provided by the manufacturer. This chuck key
is spring loaded to prevent the chuck key from remaining in the chuck during operation
of the drill.
Fixing:
Fasten base of drill press to the floor before using to ensure no tipping, sliding of drill
press. The set screws of the head frame should be secured tightly before using this
machine.
Power:
When mounting the motor, ensure the power is disconnected. Connect to power
supply protected by a circuit breaker.
Transportation: Lifting by Forklift;
1.
If lifting equipment isn’t available, use 1ton capacity forklift under the machine
base to locate to position
2.
To move the drill press safely, place the forks of the forklift at the rear of the drill
press – the drill press must only be moved while on a pallet.
3.
Keep balance of drill press on pallet while moving with forklift.
