- 7 -
T-BAR LEG BASE FRAME
NOTE: Applies to either leg leveler or carpet pin installation.
1. Assemble snap fit cap to leg levelers (see Figure 1, page 2). Screw leg levelers or
carpet pins into T-bar leg base in holes provided. See Figure 16. Screw leg levelers
up against bottom of base. (If carpet pin is used, insert as far up as possible without
disengaging threads).
2. Assembling frames and leg bases. See Figures 15 and 17.
a. Install frame extension over T-bar upright as shown in Figure 17 and fasten with
1/4-20 x 3/4 Phillips truss head machine screws and 1/4-20 Keps nuts.
b. Install opposite extension of frame plus an extension of the adder frame into the
next T-bar upright and fasten with 1/4-20 x 3/4 Phillips truss head machine screws
and 1/4-20 Keps nuts. Continue to end of range.
3. Proceed to level and plumb frames to vertical and horizontal (see Step 5 on page 3).
Adjust levelers or carpet pins with screwdriver and install button plugs into adjustment
holes. See Figures 17 and 18.
4. Install filler channels at ends of ranges as required. Completed assembly shown in
Figure 18.
FRAMES ARE NOW READY TO RECEIVE BALANCE OF COMPONENTS.
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18
00954-30
00954-20
00954-40
14993-00
07742-00
