- 3 -
LEVELING
5. After all frames are joined in a range, stretch a nylon line from one
end of the range to the other end, at eye level. Adjust leg levelers
so that they are all bearing on the floor surface and slots in the
frame uprights are in line horizontally across face of range.
6a. Install balance of base brackets.
Force base bracket down to floor
surface. (Base brackets have a 3/4" adjustment allowance built
in).
Secure base brackets and the uprights with two (2) 1/4-20
x 3/4 Phillips truss head machine screws and two (2) 1/4-20
hex nuts. See Figure 6.
6b.
Secure each base bracket to face of upright on both sides with
#10 x 5/8 pan head sheet metal screws. See Figure 6.
IMPORTANT NOTE: Base brackets must be flush to floor to ensure
unit stability and secured with sheet metal screws to prevent bracket
from working up frame when loaded.
7. Secure base brackets together with a 1/4-20 x 3/8 Phillips pan head
machine screw and a 1/4-20 hex nut through hole at front of base
bracket in bracket depression. See Figure 7.
NOTE:
a. It is not necessary to tighten nut and bolt beyond binding point
since there is no load bearing at this point.
b. The nut and bolt should not protrude beyond the depression
of the bracket as book damage could result.
c.
Anchoring - requirements for anchoring units to floors and
walls should be reviewed and followed. See pages 5, 6 and 13.
8. Install base shelves. See page 8.
FIGURE 6
FIGURE 7
ADJUSTABLE LEG LEVELER INSTALLATION
FIGURE 8
ADJUSTABLE LEG LEVELER INSTALLATION
FIGURE 8
FIGURE 6
FRAMES ARE NOW READY TO RECEIVE BALANCE OF COMPONENTS.
FIGURE 7
07742-00
14993-00
00950-15
07742-00
