- 2 -
STANDARD WELDED FRAMES
Standard welded frames are furnished
with two adjustable leg levelers and two
snap fit cap floor glides. Carpet pins can
be substituted for levelers when specified.
See page 4 for details.
WELDED FRAMES WITH LEVELERS
1. Assemble snap fit cap to hex head of 3/8-16 x 1-1/2" leg leveler bolt. See Figure 1. (Snap
fit cap prevents bookstack units from creeping on a smooth-surfaced floor and can be
eliminated if used on a carpeted surface).
2. Screw leg levelers into weld nuts in bottom rail of each welded frame as shown in Figures
2, 3 and 8. Screw leg levelers all the way in.
3. Stand frame upright and snap a base bracket assembly into place on the inside of frame
uprights and as low as possible. (Frame should stand upright alone at this point). See
Figure 4.
NOTE:
a) Single face units have left-hand and right-hand base brackets. Double face units have
base brackets that may be used on either end.
b) Finished end brackets, if furnished, are installed on exposed ends of unit ranges.
4. Position the frame set-ups in range rows. Fasten frame uprights together, starting with the
top joining holes provided in the frame upright web, using 1/4-20 x 5/8 Phillips pan head
machine screws and 1/4-20 Keps nuts. Visually check that the slots in the adjoining frames
line up with each other.
Do not bolt through base brackets at this time. See Figure 5.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 5
00954-30
00954-70
00954-30
13974-00
07742-00
STANDARD INSTALLATION
