BorMann 036395, Manual, Page: 5 / 18

EN
WWW.BORMANNTOOLS.COM
5
Operating instructions
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Indicating the remaining battery capacity
Pull the switch trigger to indicate the remaining battery capacity.
1. Battery capacity Indicator
Indicator lamps
All three lights
(Red/Yellow/Green) ON -> fully charged
Two lights
(Red/Yellow) ON -> 30% to60% remaining capacity
One light
(Red) ON -> 10% to30% remaining capacity
Green Yellow Red
Green Yellow Red
Green Yellow Red
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Tool/battery protection system
The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool or battery is placed under one of the following conditions:
Overload protection
When the tool/battery is operated in a manner that causes it to draw an abnormally high current, the tool stops automatically. In this situation, turn the tool
off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool/battery is overheated, the tool stops automatically. In this situation, let the tool/battery cool before turning the tool on again.
Over-discharge protection
When the battery capacity is not enough, the tool stops automatically. In this case, remove the battery from the tool and charge the battery.
Lighting up the front lamp
CAUTION: Do not look in the light or see the source of light directly.
The Cordless Screwdriver comes with a LED Work lamp mounted just below the torque setting
control ring. This light illuminates the fastener being removed or installed by the screwdriver.
When you press the trigger, the Work lamp will turn on automatically and it will turn off imme-
diately when the switch trigger is released.
NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens
of lamp, or it may lower the illumination.
1. Work Lamp
Switch action
To start the tool, simply pull the switch trigger. Release the switch
trigger to stop.
1. Switch trigger