BorMann 036357, Manual

Page: 5 / 18

EN
WWW.BORMANNTOOLS.COM
5
Operating instructions
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
CAUTION: Always switch off the tool before installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly
may cause them to slip off your hands and result in damage to the tool and battery cartridge and a personal injury.
1. Button
2. Battery cartridge
To remove the battery cartridge, slide it from the tool while sliding the button on
the front of the cartridge. To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it into place. Insert it all
the way until it locks in place with a little click.
CAUTION: Always install the battery cartridge fully. If not, it may accidentally fall
out of the tool, causing injury to you or someone around you.
CAUTION: Do not install the battery cartridge forcibly. If the cartridge does not slide
in easily, it is not being inserted correctly.
Battery protection system
The tool is equipped with a battery protection system. This system automatically cuts off power to the motor to extend battery life. The tool will automatically
stop during operation if the tool and/or battery are placed under one of the following conditions:
Overload protection : The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, turn the tool off and stop the appli-
cation that caused the tool to become overloaded. Then turn the tool on to restart. If the tool does not start, the battery is overheated. In this situation, let the
battery cool before turning the tool on again.
Overheat protection When the tool/battery is overheated, the tool stops automatically. In this situation, let the tool/battery cool before turning the tool on
again.
Overdischarge protection: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery.
Indicating the remaining battery capacity
Press the check button on the battery cartridge to indicate the remaining bat-
tery capacity. The indicator lamps light off immediately when release the check
button. Below for detail remaining capacity information.
1. Indicator lamps
2. Check button
Indicator lamps
75% to 100%
25% to 50%
10% to 25%
Lit
GREEN
ORANGE
RED
ORANGE
RED
RED
Remaining
capacity
Off
NOTE: Depending on the conditions of use and the ambient temperature, the
indication may differ slightly from the actual capacity.