Borg & Overstrom T1, Install & Operation Manual

Page: 18 / 42

Using the M5 allthreads
as provided locate them
into the base of the tap
and tighten till secure. Fit
the gasket on the base
of the tap.
When planning and
providing for the
connection to the
services, always allow
for easily accessible
service isolator fittings
and for the position of
an external water filter.
Identify a suitable
position for the faucet.
Refer to the cut out
guide template.
Ensure worktop is level
to allow system to drain.
Allow for the space
needed for forming the
required cut out. Relate
the selected position to
the underneath of the
counter and check for
any obstructions.
Also allow for the height
of the swan neck under
any overhanging
cupboard/shelf.
Carefully form the
needed hole, using the
correct type of cutter for
the work surface
material.
Observe all local
occupational health and
safety requirements.
Allow sufficient space
for fitting the worktop
fixing bracket.
Tighten the 2 fixing
flange nuts so that the
worktop bracket is fixed
up against the underside
of the worktop.