![background image](http://html.mh-extra.com/html/boretti/puro-quadro-800/puro-quadro-800_installation-manual_2788450019.webp)
Installation of the Plasma filter in surface hoods
Box content:
Plasma filter
Données techniques:
Power 210-250v ~ 50Hz, 10W
The Plasma filter can be easily installed on surface hoods by simply connecting it to the motor
outlet and channelling it to a ventilation grid, using flexible piping (non supplied). See below
installation examples (Fig. 1, 2 and 3). The air outlet of the hood and the type of motor can vary
depending on the model. A plinth of a minimum 10 cm is required to host the filter.
For optimum performance, it is advisable to install the filter as far as possible, without exceeding
3 m.
To install the filter, proceed as follows:
1. Prior to installation, remove the drawers for easy access.
2. Disconnect the hob and the hood as a precaution.
3. Take the necessary measurements to calculate the piping definition and the additional
conduits needed.
4. Mount the entire system outside the cabinet and connect it to the hood as appropriate.
5. Place the system inside the cabinet and connect it to the hood as appropriate.
6. Connect the hob, the hood and the filter to the independent power supplies (do not use
power strips).
7. Set the plinth up by fixing the recirculation box to the grid; hang the grid to its magnets and
assemble the box.
GB
RECOMMENDED ACCESSORY
Page 19 of 36
Installation examples
White lacquered grid to fit the tube ducts.
Fixation by magnets.
Summary of Contents for PURO QUADRO 800
Page 30: ...Pagina 30 di 32 ...