bora Pro PKG3, Operating And Installation Instructions

Page: 20 / 44

EN
20
Installation
www.bora.com
5.6.3 Fitting the control knob
4
3
5
2
1
Fig. 5.16
Structure of control knob
[1] Knob housing
[2] Universal nut
[3] Sticker
[4] Knob ring
[5] Wave spring
i
In the case of steel fronts, wave springs must not be used.
The corresponding installation steps are to be omitted.
Fig. 5.17 Fitting the control knob
Fig. 5.18 Wave spring when installation is complete
X
X
Remove the knob ring [4].
X
X
Unscrew the universal nut [2].
X
X
Remove the wave spring [5].
X
X
Insert the knob housing [1] from the front through the hole in
the panel.
X
X
Attach the wave spring [5] to the knob housing [1] from the
rear (not in the case of steel fronts).
X
X
Screw the universal nut [2] onto the knob housing [1] from the
rear and tighten a little.
X
X
Align the knob housing [1] so it is level.
5.6.2 Example bore holes
≥40 ≥70
90 90 90
Ø50 ±0,5
90 196 196
370 370 110
1 1
3
1 2
4 3 6 5
Fig. 5.14 Drilling pattern for 2 cooktops, 1 cooktop extractor
and 2 sockets
[1]
Boreholes for socket (x 2 external)
[2]
Bore holes for control knobs (x 5)
[3] Cooktop (x 2)
[4] Cooktop extractor
[5] Worktop
[6] Fixed front panel
≥70 ≥40
90 90 90 90 90 196 196 196 196
370 370 370 110
1 1 1 1
110
Ø50 ±0,5
3 3 1 2 4 4 3 6 5
Fig. 5.15 Drilling pattern for 3 cooktops, 2 cooktop extractors
and 2 sockets
[1] Boreholes for socket (x 2 external)
[2] Bore holes for control knobs (x 8)
[3] Cooktop (x 3)
[4] Cooktop extractor (x 2)
[5] Worktop
[6]
Fixed front panel