EN
19
Installation
www.bora.com
Preparing the mounting clamps
4
3
2
1
Fig. 6.12 Mounting clamp on right (flush mounting)
[1]
Worktop thickness labelling (in mm)
[2]
Cut mark (4x)
[3]
Fastening lugs (2 on each side)
[4]
Marking for flush mounting
4
3
2
1
Fig. 6.13 Mounting clamp on left (surface mounting)
[1]
Worktop thickness labelling (in mm)
[2]
Cut mark (4x)
[3]
Fastening lugs (2 on each side)
[4]
Marking for surface mounting
INFO
The symbols on the mounting clamps show
which side to use for surface mounting and for
flush-mounting.
INFO
The labels shows the cutting mark to go with
the worktop thickness.
X
X
If necessary, shorten the mounting clamps in line with
the worktop thickness.
X
X
To do this, cut the mounting clamps at the appropriate
cut marks using a cutter.
1
2
Fig. 6.10 Height adjustment plates
[1]
Height adjustment plate
[2]
Cooktop extractor
X
X
If applicable, insert the height adjustment plates [1].
0,5
2
1
1
Fig. 6.11 Installing the cooktop extractor
[1]
Cooktop
[2]
Cooktop extractor
Q
Q
The cooktop extractor [2] must be installed 0.5 mm
higher than the cooktops [1].
6.5.3 Securing the cooktop extractor
The cooktop extractor is secured using the four mounting
brackets provided. The mounting brackets have offset
fastening lugs, with one side for surface mounting and
one for flush mounting. The mounting clamps can be
adjusted to the thickness of the worktop.
Summary of Contents for PKA1UMEN-001
Page 43: ......
