bora CKCB, Installation Instructions Manual

Page: 17 / 36

EN
17
Installation
www.bora.com
4.4.2 Worktop and kitchen units
X X
Create the worktop cut-out taking into account the
specified cut-out dimensions.
X X
Make sure that the cut surfaces of the worktops are
properly sealed.
X X
Comply with the instructions of the worktop manufacturer.
Q Q
Cross bars on the kitchen unit in the area of the
worktop cut-out may need to be removed.
Q Q
No false floor is necessary below the cooktop. If cable
protection (false floor) is planned, the following must
be taken into account:
Q Q
It must be fitted in such a way that it can be
removed for maintenance work.
Q Q
To ensure sufficient cooktop ventilation, a minimum
distance of 15 mm to the bottom edge of the
cooktop is to be observed.
Q Q
The drawers and/or shelves in the floor unit must be
removable.
Q Q
A return flow aperture > 500 cm
2
is required in the
kitchen units for recirculation devices (e.g. by shortening
the plinth boards or using suitable slatted plinths).
4.5 Cut-out dimensions
Worktop overhang
≥50 x
Fig. 4.4 Worktop overhang
X X
Please note the worktop overhang x when creating the
worktop cut-out.
4.2.2 Scope of delivery of the cooktops
Scope of delivery
CKFI/CKI/CKIW/CKCH/CKCB/CKT
Quantity
Cooktop 1
Fixing screws 4
Height adjustment plate set 1
Cooktop mounting bracket 4
Automatic extraction system cable 1
Additional scope of delivery CKFI, CKI, CKIW, CKCH, CKCB
Glass ceramic cleaning instructions 1
Glass ceramic scraper 1
Additional scope of delivery CKT
Tepan spatula 1
Tab. 4.2 Scopes of delivery of the cooktops
4.3 Tools and aids
The following special tools are required to correctly install
the system:
Q Q
Screwdriver/Torx screwdriver 20
Q Q
Black, heat-resistant silicone sealant
Q Q
Fine saw
4.4 Assembly instructions
4.4.1 Safety clearances
X X
Maintain the following safety clearances:
1
3
2
Fig. 4.3 Minimum distance
[1]
Minimum clearance of 50 mm at the front and back from
the worktop cut-out to the edge of the worktop.
[2]
Minimum clearance of 300 mm from the left and right of the
worktop cut-out to the adjacent cabinet or wall.
[3]
Minimum clearance of 600 mm between the worktop and
cabinet above (650 mm in the case of gas devices).