EN
17
Installation
www.bora.com
Installing the cooktop
1
2
Fig. 5.9
Installed cooktop with cooktop extractor
[1]
Cooktop
[2]
Cooktop extractor
X
X
Insert the cooktop [1] next to the cooktop extractor [2]
that has already been installed in the centre.
INFO
The cooktop [1] lies on the side rail of the
cooktop extractor [2], which stabilises it.
X
X
Precisely position the cooktop [1].
X
X
If necessary, use the height adjustment plates to
adjust the cooktop’s installation height.
1
2
Fig. 5.10 Cooktop and height adjustment plates
[1]
Cooktop
[2]
Height adjustment plates
For surface mounting
X
X
Make sure that the sealing tape for the cooktop is flat
against the worktop.
Q
Q
No sealing tape is required on the side of the appliance
adjacent to the extraction system as the extraction
frame can otherwise be damaged.
X
X
With surface mounting, attach the enclosed sealing
tape [2] to the underside of the device before installing
it. Do not leave any gaps with the exception of the side
adjacent to the extraction system.
X
X
With flush installation, attach the enclosed sealing tape
to the horizontal cutting edge in the worktop cut-out,
even if you seal the device with a silicone sealant [1] or
similar.
X
X
Note down the type designation and build number of
the device (FD number) on the back of this manual.
Both details can be found on the nameplate on the
underside of the device.
5.5 Installing the cooktop
INFO
Clearance of one millimetre should be planned
between the built-in appliances.
INFO
A clearance of two millimetres should be
planned around the built-in appliances.
INFO
Cable protection (false floor) should be
mounted below the appliances. This needs to
be removable for maintenance work.
>
20
50
Fig. 5.8
Side view of the cable protection and ventilation
Q
Q
Cross bars on the kitchen unit in the area of the
worktop cut-out may need to be removed.
Q
Q
The drawers and/or shelves in the floor unit must be
removable for maintenance and cleaning purposes.
Summary of Contents for CG11
Page 31: ......
