bora CCH1, Operating And Installation Instructions

Page: 16 / 28

EN
16
Installation
www.bora.com
5.5 Installing the cooktop
INFO A gap of one millimetre should be planned
between the built-in appliances.
INFO A gap of two millimetres should be planned
around the built-in appliances.
INFO Cable protection (a false floor) should be
mounted below the devices. This needs to be
removable for maintenance work.
>
20 50
Fig. 5.8 Side view of the cable protection and ventilation
Q Q
Cross bars on the unit in the area of the worktop cut-
out may need to be removed.
Q Q
The drawers and/or shelves in the floor unit must be
removable for maintenance and cleaning purposes.
5.5.1 Installing the cooktop
1 2
Fig. 5.9 Built-in cooktop with cooktop extractor
X X
Insert the cooktop [1] next to the cooktop extractor
[2] already installed in the centre.
INFO The cooktop [1] rests on the lateral bar of the
cooktop extractor [2] and is thereby stabilised.
Attaching the sealing tape
1
2
Fig. 5.6 Sealing tape, flush installation
[1]
Black heat-resistant silicone sealing compound
[2]
Sealing tape
2
1
Fig. 5.7 Sealing tape with surface installation
[1]
Black heat-resistant silicone sealing compound
[2]
Sealing tape
X X
With surface installation, attach the enclosed sealing
tape [2], on the underside of the device before instal-
ling it. Do not leave any gaps.
X X
With flush installation, attach the enclosed sealing
tape to the horizontal cutting edge in the worktop cut-
out, even if you seal the cooktop with a silicone
sealing compound [1] or similar.
X X
Note down the type designation and build number of
the device (FD number) on the back of this manual.
Both designations can be found on the nameplate on
the underside of the device.