Booth TRM9HC, Product Manual

Page: 2 / 12

2
Contents
Safety
The TRM9HC model uses a R290 (Care 40, Propane) refrigerant. Below are some
safety points which the end user must adopt to mitigate the risk of unsafe conditions
arising.

Service must only be carried out by a suitably qualified refrigeration engineer.

The unit must be isolated from the electricity supply before removal of the
covers.

Do not damage/puncture the refrigeration circuit.

This unit is not intended for use in lobbies or locations of egress, such as
hallways or public corridors.

Ventilation openings must be clear of obstructions.

There must be a gap of at least 100mm between the appliance and a wall or
other restriction.

Where components are replaced, the new component must be of the same
type.

Operate the unit within (ambient) operating temperatures; 16
⁰C to 38⁰C.
Introduction
The TRM9HC is a dry block chiller designed to provide chilled still water by pa ssing water
through a stainless steel water coil in the “cold block”.
The TRM9HC in standard
configuration is designed as a single product chiller with an option of two depending on
targeted drink temperature.
Important:
It is essential that the TRM9HC be turned off during cleaning to prevent
the cleaning fluid in the product line from freezing.
Section Page Section Page
Safety, Introduction & Specification 2-3 Fault Finding 9
Installation &
Commissioning
4 Replacement Parts 10
Cleaning 5-6 Removal, Transportation
and Disposal
11
Schematics 7-8
Introduction and Specification