Voorhout • Groningen • Weert • Hoogerheide
T
+31(0)88 7865800
I
elsto.eu
05/2013
39
Quick Start Guide
Agile
Error messages and warnings during setup
Error messages
Fault clearance
Check rated motor values in parameters 370…376. Correct the values if
necessary. Repeat Setup. Check motor cable connections and frequency inverter
connections.
Warnings
Check rated motor values in parameters . Correct the values if
necessary. Repeat Setup.
The
following causes are possible: The motor cable cros- section is not sufficient.
The motor cable is too long. The motor cable is not connected correctly.
Check P372 (rated speed), P375 (rated frequency).
The machine data for star connection is entered, but the motor is connected in
delta. For star connection change the motor cable connection. For delta connec-
tion check the entered rated motor values. Repeat Setup.
The machine data for delta connection is entered, but the motor is connected in
star. For delta connection change the motor cable connection. For star connection
check the entered rated motor values. Repeat Setup.
Check motor connection and frequency inverter connections.
-
Press ESC to correct a parameter value after an error message or after a warning message.
-
Press ENT to ignore a warning message. Setup is continued. It is recommended to check
the entered data.
Error messages and warnings during operation
Error messages
Fault clearance
Frequency inverter overloaded. Check load behavior. Check motor parameter
settings.
Overtemperature. Check cooling, fan, sensor and ambient temperature.
Low temperature. Check ambient temperature and electrical cabinet heating.
Motor temperature too high or sensor defective. Check connection on X.12.4.
Phase failure. Check motor and wiring.
Overloaded, short circuit or earth fault, motor current or phase failure. Check load
behavior and ramps (P420 … P423). Check motor and wiring.
DC link voltage too high or too low. Check deceleration ramps (P421, P423) and
the connected brake resistor. Check mains voltage.
Power failure or phase failure, voltage brake- chopper or motor chopper too high.
Check mains voltage, mains fuses and circuit.
Electronic voltage (DC 24V) too high or too low. Check wiring of control terminals.
Maximum frequency achieved. Check control signals an settings.
Check deceleration ramps P421, P423) and the connected brake resistor.
F1201
F1204
...
Internal STO-error.
Please use the instruction manual for details.
F1205
Enable signals STOA and STOB were not actuated at the same time, but with a
time offset bigger than 5 seconds. Check the circuitry of the enable input signals.
F1206
F1209
...
Internal STO-error.
Please use the instruction manual for details.
Minimum output current. Check motor and wiring.
Reference value signal on input X12.3 faulty, check signal.
Overcurrent on input X12.3, check signal.
Overcurrent on input X12.4, check signal.
F0102 F0103
,
F0400 F0403
,
F0500
F0507
...
F0700
F0706
...
F0801 F0804
,
F1100
F1110
...
F1310
F1401
F1407
F1408
SA001
SA004
...
SF001
SF022
...
SA021
,
SA022
SA041 SA042
,
SA051
SA052
SA053
