150
TROUBLESHOOTING
Monitoring Beeper Coded Signals
CODED SIGNALS
POSSIBLE CAUSE
REMEDY
2 short beeps
(when engine is started).
DESS/RER pilot lamp
also blinks.
Confirms that
proper tether cord
cap is installed.
Engine can rev
above pulley
engagement.
Normal condition.
1 short beep every
1.5 seconds
(when engine is started).
DESS/RER pilot lamp
also blinks. Engine
cannot reach pulley
engagement speed.
Vehicle cannot be driven.
Bad DESS system
connection.
Reinstall tether
cord cap correctly
over post.
Defective tether
cord cap.
Use another
programmed tether
cord cap.
Dirt or snow in
tether cord cap.
Clean tether cord
cap.
Defective DESS
post.
Replace DESS
post.
1 long beep per second. Reverse is
selected.
Vehicle can be
driven in reverse.
3 short beeps per
second. DESS/RER pilot
lamp also blinks. Engine
cannot reach pulley
engagement speed.
Vehicle cannot be driven.
Wrong tether cord
cap is installed.
Install proper tether
cord cap. Program
key into electronic
module.
3 short beeps per
second. Engine
overheating pilot lamp
also blinks.
Engine is
overheating.
Stop engine
immediately and
allow to cool.
Check cooling
system.
3 short beeps per
second.
Low battery
voltage.
Check battery and
charging system.
mmo2005-001b_3.fm Page 150 Friday, November 21, 2003 12:28 PM
