Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
48
Setting inspection
Lower the saw frame to the lowest position. If the saw frame
is on the lower stop and the limit switch responds, the limit
switch adjustment is correct. Make the limit switch
adjustment in failing which.
Limit switch setting
1)
Release the nut of the stop screw of the limit switch and
screw the screw.
2)
Lower the saw frame to the lower stop and switch by
button
4
(START)
semi-automatic cycle.
3)
Screw out the stop screw of the limit switch, until the saw
band drive is not stopped.
4)
Secure the screw with nut and check limit switch
adjustment again.
