Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
36
The optimal running in of the saw band produces ideal
rounded cutting edges and therefore the conditions for an
optimal service life.
Note:
Run regrinding saw bands too!
15.5. Saw band dismantling
1)
Press the button
8
to lift the saw arm to maximum
position.
2)
Switch off hydraulic by button
Stop 5
.
3)
Switch
Deblock 16
to position
1
.
4)
Open covers of both drive wheels.
5)
Dismantle yellow band cover.
6)
Release screw tightening brush position.
7)
Release the saw band by pressing left button.
8)
Draw the saw band down from driving wheels.
9)
After carefully take the saw band out of guiding cubes.
15.6. Saw band installation
1)
Prior to installation, clean all track wheels, guide cubes
and inner side of the arm thoroughly of all traces of chips
and dirt. Keep in mind the teeth direction when installing the
saw band.
2)
Insert new saw band in the guide cubes. Make sure the
saw band runs between both guide rollers and it is pushed
all the way to the top.
