Operator's Manual
Rev. BXXMP.01 January 2020
OPERATING INSTRUCTIONS
ENTERING THE MACHINE
You can enter the machine the left hand side. There are 3
handles installed on the frame of the cab, so the operator can
grab them when entering or exiting the machine.
For entering from the left side:
- Grab one handle with your left hand.
- Put your left foot on the entering step (the one with the
aluminum plate).
- Go up and enter the right leg over the seat, taking care with
your head no to crash against the overhead frame.
Use only the right side in case of emergency, or if it's not
possible to access the left side, as it's more difficult to
access it due to the joysticks dashboard
All the B30 MP are equipped with semi cabin (front, top and rear
windows). In case of emergency, you can break front or rear
windows to exit from the cab. The glasses are laminated to
prevent injuries in case of break.
ADJUSTING THE SEAT
A correct adjustment of the seat ensures the operator a safe and
comfortable driving. The forklift seat is fitted with devices which
allow for the adjustment of the springing, the height and the
distance from the controls.
- Seat distance from the controls
The seat is equipped with an adjusting device to slide the same
seat forward or back with respect to the steering column.
To adjust the seat, pull the lower front right lever up, and push
the seat to the desired direction. Then release the lever and
make sure that the seat locks in position.
- Springing adjustment
Pull out and rotate the lower front knob by 180°. Then pull the
lever up and down to adjust the springing degree required. After
that put it back.
- Back angle adjustment
Pull the lower right lever up, and push the seat back to the
desired direction. Then release the lever and make sure that the
seat locks in position.
- Arm rests height adjustment
You can adjust the height of the arm rests with the knob below
them, until you find a relaxed position of the right arm over the
joysticks.
DANGER
The seat is for one person only
Don’t adjust the seat when the machine is moving
FASTENING THE SEAT BELTS
Sit correctly in the driving seat, then:
- The safety belts are equipped with reel re-tractor. To fasten the
belt, pull tab
1
and push it into buckle
2
.
- To release the belt, push button
3
and remove the tab from the
buckle.
- Make sure that the buckle is correctly located at the hip point
and not on the stomach.
- Operate the end adjusters to reach the length you wish and
make sure the buckle is always in the middle.
STEERING COLUMN ANGLE ADJUSTMENT
The steering column can be adjusted in angle, pushing the tab in
the below, and then moving it grabbing from the steering wheel.
20/34
BOMAQ INDUSTRIES SLU
MODEL BXX MP
