17
12/2011
Connect the cold water supply hose to a threaded 3/4(inch) connector and make
sure that it is fastened tightly in place. If the water pipes are new or have not been
used for an extended period of time, let the water run to make sure that the water is
clear. This precaution is needed to avoid the risk of the water inlet to be blocked and
damage the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the house hot water line (centralized sys-
tem, heating system), as long as it does not exceed a temperature of 60 C. In this case, the wash
cycle time will be shortened and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those for the
connection to the cold water line.
WARNING:
To avoid that water pressure remains in the inlet hose, please close the hydrant after
using.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of
40 mm, or let it run into the sink, making sure to avoid bending or
crimping it. Use the special plastic hinge that comes with the ap-
pliance . The top of the hose must be at a height between 500
mm (min) and 1100 mm (max).
The free end of the hose must not be immersed in water to avoid
the back flow of it.
How to Drain Excess Water From Hoses
If the sink is 1100 mm higher from the floor, the excess water in hoses cannot be drained directly into
the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is
held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 meters; otherwise the cleaning effect of the dishwasher could be reduced.
Power Connection
WARNING
for your personal safety:
- Do not use an extension cord or an adapter plug with this appliance.
- Do not, under any circumstances, cut or remove the earthing connection from the power cord.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropri-
ate power supply. Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and
provide separate circuit serving only this appliance.
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate.
Only
insert the plug into an electrical socket which is earthed properly.
If the electrical socket to which
the appliance must be connected is not appropriate for the plug , replace the socket, rather than using
a adaptors or the like as they could cause overheating and burns.
Grounding Instructions
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the
risk of electric shock by providing a path of least resistance for the electric current. This appliance is
equipped with a cord having an equipment-earthing conductor and an earthing plug. The plug must be
plugged into an appropriate outlet that is installed and earthed in accordance with all local standards
and requirements.
WARNING:
- Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
